E-maxx 8:1 Gear-reduction
E-maxx 8:1 Zusatz-Getriebe
here is a setup for our rock-crawling fan's !
almost unlimited gear-ratio options all the way down to rock-busting 8:1,
with the use of 2x 10 tooth pinion gears . with 9 tooth pinion-gears even a gearratio of almost 10:1 possible
by the use of just 1 motor runtime will be at least twice as long , but probably 3-4 times as long ,
since of that high gear-reduction the load ( current-flow ) of the motor will be drastically reduced ,
and the torque is 4 times as from a stock E-maxx.
A stock E-maxx comes with 18 tooth motor-pinions .
My gear-reduction uses a 44 tooth spur-gear , with a 10 tooth motor-pinion you have a 4.4:1 gear-ratio.
On the outputshaft of that gear-reduction I also use a 10 tooth pinion what will give an additional
1.8:1 gearratio = 7.92:1.
The output-shaft of that gear-reduction is a 1/8 inch ( 3.18 mm ) shaft , the same as a motorshaft .
means any 32 pitch pinion-gear can be used ( the same type as the stock E-maxx pinion's ).
Motor-pinions from 9 to 22 tooth can be used for the motor as well for the gear-reduction output-shaft.
hier nun ein Zusatzgetriebe fuer die Trial und Felsen-kletterei.
Fast unbegrenzte Untersetzungsmoeglichkeiten bis runter auf brutale 8:1 bei der
Verwendung von 10 Zaehne Ritzel .
Mit 9 Zaehne Ritzel kann sogar eine Untersetzung von fast 10:1 erreicht werden .
Bei der Verwendung von nur einem Motor verdoppelte sich die Laufzeit .
Wahrscheinlich sogar verdreifacht oder vervierfacht , da die Belastung ( Stromfluss ) durch die hohe Untersetzung erheblich verringert wird , wobei sich das Drehmoment verachtfacht ,
bzw vervierfacht , da ja nur 1 anstelle 2 Motoren verwendet wird .
Ein stock E-maxx kommt mit 18 Zaehne Motoren-ritzel .
Mein Zusatzgetriebe hat ein 44 Zaehne Spurrad , mit einem 10 Zaehne Ritzel gibt das bereits 4.4:1 .
An der Ausgangswelle verwende ich ebenso ein 10 Zaehne Ritzel was eine 1.8:1 Untersetzung ergibt .
Somit alles in allem eine 7.92:1 Untersetzung.
Die Ausgangswelle ist eine 3.18mm Welle ( gleicher Durchmesser wie Motorenwellen ),
heisst hier koennen ganz normale Motoren-ritzel verwendet werden .
Verwendbare Ritzel fuer Motor wie auch Ausgangswelle reichen von 9 bis 22 Zaehne .
Willy Loewer CustomRCmodels Febr.2003
|